In recent years, with the continuous advancement of science and technology, the glass has been used in the field of glass and glass cutting machines. In the past few years, the broad prospects have been favored by more and more people, and more and more enterprises have begun to The production of the film on the table, the author has been engaged in glass coating business for many years, here I would like to remind you to pay attention to the following four misunderstandings:
The first thing we want to look at is the cutting speed of the equipment. Of course, we must talk about the speed under the premise of satisfying the cutting precision. Since it is difficult to judge whether it reaches a higher speed, it can be equipped with the servo drive of the cutting machine. Software simulation to see if the motor's speed can be high, compare the data of various types of equipment.
Second, it is also very important, the cutting precision of the equipment, this should be selected according to their actual needs, this can not just look at the introduction of the product manual and the manufacturer's words, mainly in the technical depth, such as: knife wheel The control, the running-in of the rack and pinion, the design is reasonable, the level of the control system, and then the measurement in the actual cutting, in order to fully grasp the synchronous control level of the cutting machine part and the control system.
Third, the automatic typesetting optimization function of the equipment, due to the particularity of its work, it is generally rare to arrange people with high education or level to work, so the operation of the cutting machine is required to be simple, easy to understand, safe and stable. Maintenance is simple, avoiding the embarrassing situation that affordable equipment can't afford equipment. Optimization should be applied to your own actual situation, can not pursue 100% optimization rate, resulting in can not be smashed, work efficiency is reduced, of course, can not be fully optimized according to the manufacturer's specifications, because the domestic original glass not only causes the cutter to fall, but also shaped The cutting graphics library is flexible and flexible, and CAD and Solidworks software graphics files can be imported into the library, which makes it easy to work.
Fourth, the equipment requires simple and convenient maintenance. The input and output and mechanical sensors should not be equipped too much. The unnecessary switches and indicators should be as small as possible, because once a certain device on the machine fails, it will affect the use of the cutting machine. The fewer the parts, the simpler the design, the lower the probability of failure, the less wiring, and the ease of finding faults and replacing parts. Moreover, it is better to debug the status of each input and output signal on the display screen, and the maintenance cost is an important factor that must be prioritized when purchasing the device.
These aspects are the main points that we should pay attention to when purchasing the film. Of course, there are other small aspects, including after-sales service and logistics. It is also very important for the general enterprises to do. It is necessary to pay attention to some newcomers. The small factory, after-sales service and logistics are generally not very good, so I recommend to contact a company that has at least three years of production and operation experience.
The above is the matter that needs attention in the purchase. I hope to help you. If you have any other questions, please call Nanjing Renyi Coating Co., Ltd.
Bomber Jacket Baby,Bomber Jacket Aesthetic,Classic Bomber Jacket,The Bomber Jacket History
Nanjing Tongde Garment Co., Ltd. , https://www.greenwearofficial.com